Flintlock Gun Shot and Shooting – 12 "Simple" Steps

If you think modern weapons are complex, consider the frontiers of the 17th and early 18th centuries. Their survival often depends on his ability to quickly load and shoot a rifle. Loading and shooting a flintlock is a twelve-step process that is not always successful. (As we all know, the flintlock is unreliable in shooting.) Because Daniel Boone is known as a crack on his Kentucky rifle, he must be a world-class rifleman, just because it is full and ready to fire – Not to mention actually hitting anything with it – it's a long and complicated process!

The following are the twelve steps required to load and shoot a rifle or rifle:

1. Bite the carton and tear it open with your teeth.

2. Push the striker forward (called frissen ) and pour a small amount of powder into the flash tray.

The powder in the pan is used to ignite the main powder charge in the combustion chamber and then push the barrel out of the barrel. However, sparks striking from flint often cause a rapid explosion in the pot and fail to ignite the main charge. This is where we get the expression, "a short-lived".

3. frissen is pushed back to cover the flash disk

4 . Hold the muzzle with the muzzle facing up.

5. Pour the remaining powder from the muzzle into the barrel.

6. Insert the shot into the barrel.

7. Push the cartridge paper into the barrel (called the “filler”).

8. Remove the push rod from the storage tube under the barrel and use it to push the batt and ball into the barrel.

It is easier to use a rifle than to use a rifle. The rifle barrel has a slightly larger diameter and a smooth inner surface. A rifle cuts into a spiral groove on the metal inside the barrel, causing the ball to rotate as it leaves the barrel, thereby improving flight accuracy. The fit of the bullet inside the barrel must be tighter to transmit the rotation, so the groove and smaller diameter make it more difficult to impact the filler and ball all the way into the firing chamber.

Rifles can be shot more and more accurately, but their slower rate of fire is the main reason why the army continued to use muskets until the late 19th century. In combat, the time to reload and shoot is a matter of life and death, and fire rate is an important consideration. The invention of metal cartridges and stern loading (loading bullets through the opening in the rear of the barrel near the launch chamber) ultimately ended the rifle's dominant position in military applications.

9. Replace the push rod in the storage tube

10. Raise the rifle to the shooting position and rest the butt on the shoulder.

11. Pull back the hammer.

12. Aim and shoot.

We have all seen the scenes in the movie, a brave early pioneer who pressed the time in the imminent danger, leaving the mast in the barrel and firing, instead of spending extra precious Time to remove it from the barrel and replace it in the storage tube. When the charge is emitted, the pusher then becomes part of the ammunition that is pushed out of the barrel.

In extreme cases, those extra seconds are a matter of life and death, which may have been completed. But unless you have time to restore the putter from anywhere in the flight, its loss will make the weapon useless, and it is difficult to find alternatives on the border, so border personnel seem to be less accustomed to this practice, unless it is [19659020] is a matter of life and death.

No matter what kind of Ramrod is used, no matter what kind of Ramrod, it is clear from the above steps that loading and firing a flintlock is far from a simple proposition. Daniel Boone and his Kentucky rifle and countless other frontiers and soldiers who use the rifle weapon are certainly worthy of our admiration, and can do this with such high flexibility and skill!